Alpine MRV-F300

4-channel car amplifier — 50 watts RMS x 4

  • In 4-channel mode, it delivers 50 watts RMS to each of your car’s front and rear speakers, making for some sweet sound on your drive.
  • You can also run this amp in 3-channel mode, powering a subwoofer with 150 watts RMS while driving a pair of full-range speakers with 50 watts each.
  • Or, if you need a good amp for bass, you can switch the amp to 2-channel mode and send up to 150 watts RMS each to a pair of subwoofers.
Learn More

Alpine MRV-M250

Mono subwoofer amplifier — 250 watts RMS x 1 at 2 ohms

Alpine makes it a little easier to get great bass in your vehicle, especially if you drive a compact car. Their V-Power Series MRV-M250 mono subwoofer amplifier sends up to 250 watts RMS to your sub, guaranteeing some strong bass on your drive. This versatile amp can even drive a 1-ohm load, so you can run multiple-sub configurations safely. And Alpine made this amp so small — about the size of an outstretched hand and just over 2″ tall — it can fit almost anywhere.

Learn More

Alpine MRV-M500

Mono subwoofer amplifier — 500 watts RMS x 1 at 2 ohms

Alpine makes it a little easier to get great bass in your vehicle, especially if you drive a compact car. Their V-Power Series MRV-M500 mono subwoofer amplifier sends up to 500 watts RMS to your sub, guaranteeing some powerful bass on your drive. This versatile amp can even drive a 1-ohm load, so you can run multiple-sub configurations safely. And Alpine made this amp so small — it’s got less than an 8″ by 8″ footprint and it’s just over 2″ tall — it can fit almost anywhere.

Learn More

Alpine MRV-V500

5 Channel V-Power Digital Amplifier

Learn More

Alpine MRX-M110

Mono subwoofer amplifier — 1,100 watts RMS x 1 at 2 ohms

Alpine’s X-Power MRX-M110 mono amplifier uses the latest amp technology to play your music loud and clean without taking up much space. And this compact amp employs some of the same circuitry developed for Alpine’s top-of-the-line PDX digital amps, so it’ll bring exceptional sound to almost any ride.

Learn More

Alpine PDR-F50

4-channel car amplifier — 85 watts RMS x 4

Welcome the new digital PDR-Power series of Class-D amplifiers. The PDR-Power amplifiers incorporate many of Alpine’s best in class digital technologies, high performance and signature sound.

Learn More

Alpine PDR-M65

Mono subwoofer amplifier — 450 watts RMS x 1 at 4 ohms

The PDR-Power amplifiers offer the best performance in their class, redefining expectations in the high-power compact amplifier category. Thanks to trickle-down technology, our in-house engineering team has taken many of the patent-pending technologies introduced in the industry-leading PDX series and infused them in the new PDR-Power amplifiers. The PDR-Power amps provide you with the absolute widest bandwidth, best signal-to-noise, lowest distortion and highest damping factor of any amplifier in their class without sacrificing power.

Learn More

Alpine PDR-V75

5 Channel Amplifier — 100W RMS x 4 + 350W RMS x 1 @ 2 Ohms

Learn More

AudioControl 6XS

6-Channel Electronic Crossover

Don’t let your crossover be the weak link in your car audio chain. AudioControl’s 6XS 6-channel crossover uses a steep 24 dB per octave slope to separate your high and low frequencies, along with a built-in line driver that’ll beef up the signal from an anemic receiver.

Learn More

AudioControl DM-608

Digital signal processor — 6 inputs, 8 outputs

Learn More

AudioControl DM-810

Digital signal processor — 8 inputs, 10 outputs

Learn More

AudioControl Epicenter Plus

Bass processor with aux input for factory or aftermarket systems (Gray)

The Epicenter Plus processor from AudioControl will maximize the low-frequency power and punch of any bass system, whether you’ve got a simple powered tube or a full-blown competition setup. You can connect the Epicenter Plus to any stereo, and its speaker-level inputs will even accept the output from a high-power factory amplifier. Simply install this processor between your car’s receiver and your outboard amplifiers, and hear what you’ve been missing.

Learn More

AudioControl EQS

6 channel trunk-mount equalizer

Learn More

AudioControl EQX

2 channel trunk-mount equalizer with crossover

Learn More

AudioControl LC2i

2-channel line output converter for adding amps to your factory system

Looking for great sound from your factory radio? Would you like to upgrade your car’s premium system? AudioControl’s LC2i line output converter takes amplified speaker-level signals and converts them into high-quality preamp signals that can be fed to another processor or amplifier. In other words, it lets you create an awesome car audio system without disturbing your factory controls or features.

Learn More

AudioControl LC6i

6 channel line out converter

Learn More

AudioControl LC7i

6-channel line output converter with bass restoration — add amps to your factory system (Gray)

This LOC lets you amplify your factory system and restores the bass
Your car’s stereo has great features, like steering wheel controls, built-in Bluetooth®, or navigation, but the sound is terrible. AudioControl’s LC7i 6-channel line output converter lets you hook up aftermarket amps, speakers, and subs to almost any factory stereo, allowing you to improve the sound without losing any of the factory features. It takes the speaker outputs of your factory radio or amp, converts it to a clean, unified, preamp-level signal, and then sends it along to your amps so you can enjoy some real power and impact in your music.

Learn More

AudioControl Matrix

6 channel line driver with optional level control

Learn More

Focal FD4.350

Ultra Compact 4-Channel Amplifier

Learn More

Focal FPD 1.900

Mono subwoofer amplifier — 900 watts RMS x 1 at 2 ohms

Learn More
Page 1 of 3123